I am looking for U.S. hub who has Ninjaflex SemiFlex. SemiFlex is 98 Shore A hardness. It will give just a little bit, but is quite hard. I need someone who can actually print the part at 98. Ninjaflex says it is no problem and has provided me with details.
Any takers?
Thanks,
Brad
i think im about 10 months late but i ordered some semiflex today to try out
Let me know if you can print it at 98 shore A. The last part I had printed from this material was only 75 shore A, big difference. To measure the hardness, you can buy a durometer on Amazon for about $50.
i dont have $50 to spend on one of those but if u would like i can mail u a sample print via usps once i get the filament in (friday) and dialed in
JC,
If you want to send me a sample, say a cube .75" then that would be great. Let me know.
i can do that how about a 19mm by 19mm by 10mm calibration cube?
1) It needs to be a cube, I don’t “trust” only 10mm for accuracy in determining hardness.
2) If you agree, are you paying for shipping?
i have no problem paying for shipping.
so u want a 3/4 in square cube?
Yes.
ok, how do i ship it?
How you ship it is up to you. Here is the ship to address:
Brad Evans
2660 Hwy 20, Ste. 610
Bend OR 97701
OK thanks, i don’t get the filament till Friday so it will be Monday or Tuesday before i can ship it out